Back Probing on bench

Obtaining a multi meter set on resistance

asuring the meter works touching both leads, meter should have a inf. reading

Note:

When dealing with back probing the main aim is not to damage any connectors, terminals and wires.

Having both leads touching the reading should be 0.0 as there is no resistance in the leads,

the reading on this meter reads 0.3 ohms meaning this is the amount of resistance in the leads of the meter.

Back probing a shell connector with attached terminals, gently placing a back probing pin down the inside of the insulation . reading 1.3 ohms - 0.3 = 1 ohm shows the amount of resistance in the terminals